Then open the ``.env`` file to setup the mail server. Modify the ``ROOT`` setting
to match your setup directory if different from ``/mailu``.
Important configuration variables
---------------------------------
Modify the ``VERSION`` configuration in the ``.env`` file to reflect the version you picked.
Open the ``.env`` file and review the following variable settings:
Set the common configuration values
-----------------------------------
- Change ``ROOT`` if you have your setup directory in a different location then ``/mailu``.
- Check ``VERSION`` to reflect the version you picked. (``master`` or ``1.5``).
Open the ``.env`` file and set configuration settings after reading the configuration
documentation. Some settings are specific to the Docker Compose setup.
Make sure to read the comments in the file and instructions from the :ref:`common_cfg` section.
Modify ``BIND_ADDRESS4`` to match the public IP address assigned to your server.
This address should be configured on one of the network interfaces of the server.
If the address is not configured directly (NAT) on any of the network interfaces or if
you would simply like the server to listen on all interfaces, use ``0.0.0.0``.
Modify ``BIND_ADDRESS6`` to match the public IPv6 address assigned to your server.
The behavior is identical to ``BIND_ADDRESS4``.
TLS certificates
````````````````
Set the ``TLS_FLAVOR`` to one of the following
values:
- ``cert`` is the default and requires certificates to be setup manually;
- ``letsencrypt`` will use the Letsencrypt! CA to generate automatic ceriticates;
- ``letsencrypt`` will use the *Letsencrypt!* CA to generate automatic ceriticates;
- ``mail`` is similar to ``cert`` except that TLS will only be served for
emails (IMAP and SMTP), not HTTP (use it behind reverse proxies);
- ``mail-letsencrypt`` is similar to ``letsencrypt`` except that TLS will only be served for
emails (IMAP and SMTP), not HTTP (use it behind reverse proxies);
- ``notls`` will disable TLS, this is not recommended except for testing.
..note::
When using *Letsencrypt!* you have to make sure that the DNS ``A`` and ``AAAA`` records for the
all hostnames mentioned in the ``HOSTNAMES`` variable match with the ip adresses of you server.
Or else certificate generation will fail! See also: :ref:`dns_setup`.
Bind address
````````````
Modify ``BIND_ADDRESS4`` and ``BIND_ADDRESS6`` to match the public IP addresses assigned to your server. For IPv6 you will need the ``<global>`` scope address.
You can find those addresses by running the following:
..code-block:: bash
[root@mailu ~]$ ifconfig eth0
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
If the address is not configured directly (NAT) on any of the network interfaces or if
you would simply like the server to listen on all interfaces, use ``0.0.0.0`` and ``::``. Note that running is this mode is not supported and can lead to `issues`_.
kaiyou
6 years ago